Machine Components Corporation
Machine Components Corporation
70 Newtown Road, Plainview, NY 11803-4382
Phone: 516.694.7222
Email: info@machinecomp.com
Print Back
Features
  • Long life under continuous slip conditions
  • Unidirectional or bidirectional operation
  • Same of different CW and CCW torques
  • Precise and stable limit torque calibration
  • Range: 1/2 to 600 oz·in
  • Same torque at breakaway as at high slip velocities
  • Corrosion resistant materials
Applications
  • Tension control of film or tape drives
  • Transmission overload protection
  • Friction loads for testing components
Recommended Mounting Procedure
  1. Coupling is slipped over one shaft and applicable screw tightened
  2. Second shaft is inserted into other end of coupling
  3. Pull loose end of coupling back about 0.02 inches and tighten applicable screw.
Federal supply code - 15531
Unit of Measure

Specifications

Upper Limit Torque (oz·in)1 N/A 20 ± 2

Unit Weight

 N/A 2.6 oz

A ± .02 (in)

 N/A 1.0000

B & C + .0010 (in)

 N/A .1560 .1875 .2500

D ± .03 (in)

 N/A 1.26

E ± .02 (in)

 N/A .50

F (in)

 N/A .55

G ± .02 (in)

 N/A .19

H

 N/A #4-40

J (in)

 N/A .040

Additional Information

N/A
The slip coupling serves as a torque limiter as well as a coupling for two collinear shafts. This coupling is equipped with hubs at both ends for pinning to the two shafts. When the load exceeds the limit torque of a slip coupling the two shafts rotate relative to each other at the full limit torque. The standard coupling is designed to operate with 3º angular or linear misalignments of up to .010" between the two shafts. The mounting hole diameters of the slip couplings can differ for the two ends, so that different diameters of "in-line" shafts can be coupled together.

This series of slip couplings is designed for long life under continuous slip conditions: The useful life of these elements is a function of the transmitted torque and slip speed. The service life figures are based on continuous duty testing.

  • 1 Stock units are calibrated with equal cw and ccw slip torques corresponding to the tabulated Upper Limit Torques. Other torques are readily availabe from full, down to 1/8 of the upper limit torque for each model. Torque values are independent of each other for cw and ccw rotation, and may be specified the same or different for the two directions.